Problem (?) mit LSI SAS Raid controller

[Marcus Sobchak]

Hei,

beim Botten einer Siemens RX300 S3 wird



[42949391.890000] megasas: 00.00.02.04 Fri Feb 03 14:31:44 PST 2006
[42949391.890000] megasas: 0x1000:0x0411:0x1734:0x1081: bus 2:slot
14:func 0
[42949391.890000] ACPI: PCI Interrupt 0000:02:0e.0[A] -> GSI 38 (level,
low) -> IRQ 98
[42949391.950000] scsi6 : LSI Logic SAS based MegaRAID driver
[42949391.950000]   Vendor: SEAGATE   Model: ST373355SS        Rev: 1751
[42949391.950000]   Type:   Direct-Access                      ANSI SCSI
revision: 05
[42949391.950000]   Vendor: SEAGATE   Model: ST373355SS        Rev: 1751
[42949391.950000]   Type:   Direct-Access                      ANSI SCSI
revision: 05
[42949391.960000]   Vendor: LSI       Model: MegaRAID SAS RMB  Rev: 1.02
[42949391.960000]   Type:   Direct-Access                      ANSI SCSI
revision: 05
[42949391.970000] SCSI device sda: 142278656 512-byte hdwr sectors
(72847 MB)
[42949391.970000] sda: test WP failed, assume Write Enabled
[42949391.970000] sda: asking for cache data failed
[42949391.970000] sda: assuming drive cache: write through
[42949391.970000] SCSI device sda: 142278656 512-byte hdwr sectors
(72847 MB)
[42949391.970000] sda: test WP failed, assume Write Enabled
[42949391.970000] sda: asking for cache data failed
[42949391.970000] sda: assuming drive cache: write through
[42949391.970000]  sda: sda1 sda2 < sda5 >
[42949391.980000] sd 6:2:0:0: Attached scsi disk sda